Message:
Hi, please tell me the best way to bleed air from lines on 1984 6.2- I know about fuel filter and tried that but still no start- I changed batteries and glow plugs and controller. It sounds like it wants to start but won't lite up.HELP!! PLEASE!!!!
DieselLuvr Guest
3/26/2004 22:52:31
RE: Air in lines IP: Logged
Message:
Loosen one injector and spin the engine until you see fuel weep out. Tighten and the engine will start.
If you have a severely airlocked injector pump you may have to open the check valve in the pump. To do this look for a wire attacked to a sensor on the rear of the block on the passenger side, pull off the connector, then take a short piece of wire and short the two conductors on the connector. Then follow the above steps.
Bob Guest
3/27/2004 11:07:32
RE: Air in lines IP: Logged
Message:
Hi, I bleed the injectors, still won't start.Glow plugs are not working on driver side. I checked the fuse on fire wall that comes from relay harness, it's ok.Any ideas? Thanks for your info DieselLuvr
louis benke Guest
4/20/2004 13:31:37
RE: Air in lines IP: Logged
Message:
break the line before the pump. If the fuel pump is working it will bleed air there first then the line after injector pump
Subject: Air in lines
